Atmospheric Tracer Techniques and Gas Transport in the Primary Aluminum Industry

Open Access
Publisher Website
Google Scholar
Abstract
The results of 35 Individual SF6 tracer tests conducted in Norway during 1978 demonstrate the applicability of tracer techniques to the study of a wide variety of pollutant transport problems found in the primary aluminum industry. Tracer methods were employed to determine the efficiency of the pollutant control system over a single reduction cell under a variety of operating conditions. Two tests conducted during normal operation gave efficiencies equal to 100 ±19% and 79 ± 12%, while a test performed during the occurrence of an anode effect yielded an efficiency equal to 66 ± 22%. Tracer investigations of flow in the wake of a smelter hall indicated that between 1 % and 11 % of secondary, roof-top emissions can become entrained in the recirculation cavity and reenter the hall through the ventilation fresh air supply. These reentry rates were observed for release heights as high as 8 m above the existing roof exhaust duct. Tracer dispersion data collected within 20 building heights of the smelter agreed very well with extrapolations of McEIroy- Pooler dispersion curves for an urban area. Dispersion curves determined from a previous wind tunnel study of flow downwind of an isolated building underestimated dispersion downwind of the vs.melter complex. The total fluoride mass flow rate measured downwind of a smelter during wet, foggy conditions indicated that wet removal rates of fluorides are in the range 3.2 × 10−4/s to 6.4 × 10−4/s. Simulation of the source with several tracer point releases and simultaneous measurement of fluoride and tracer ground-level concentrations downwind of the smelter eliminated the need for measurements of vertical profiles of wind speed and fluoride concentration during the experiment.

This publication has 1 reference indexed in Scilit: