A comparison between insulation systems available for PWM-inverter-fed motors
- 1 January 1997
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 33 (5) , 1331-1341
- https://doi.org/10.1109/28.633814
Abstract
This paper establishes the need for two levels of motor insulation systems depending upon the available voltage waveform. An analysis of the various winding stresses is presented. The different requirements for the two insulation systems are discussed (MG1-Parts 30 and 31 For General Purpose and Definite Purpose Inverter Fed Motors), and test results show the need for higher dielectric insulation when the voltage levels of Part 30 are exceeded. The differences between existing, rebuilt and new motors are also explored.Keywords
This publication has 8 references indexed in Scilit:
- Considerations in derating induction motors for applications on variable frequency drivesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Aging of magnetic wire in the presence of variable frequency, high rise time and high voltage pulsesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Transient effects in application of PWM inverters to induction motorsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Need for industry standards for A-C induction motors intended for use with adjustable frequency controllersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Effect of PWM inverters on AC motor bearing currents and shaft voltagesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1995
- Handbook of Electrical and Electronic Insulating MaterialsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1995
- Cause and analysis of stator and rotor failures in three-phase squirrel-cage induction motorsIEEE Transactions on Industry Applications, 1992
- Forces in Turbine Generator Stator WindingsTransactions of the American Institute of Electrical Engineers, 1931