Curing of compression molded sheet molding compound
- 1 June 1981
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 21 (8) , 483-492
- https://doi.org/10.1002/pen.760210808
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Heat transfer in polymer reaction moldingInternational Journal of Heat and Mass Transfer, 1980
- Effect of temperature gradients on cure and stress gradients in thick thermoset castingsJournal of Applied Polymer Science, 1980
- Heats of reaction and kinetics of a thermoset polyesterJournal of Applied Polymer Science, 1979
- Variation of thermal conductivity and specific heat during cure of thermoset polyestersJournal of Applied Polymer Science, 1979
- Effect of cure cycle on mechanical properties of thick section fiber‐reinforced poly/thermoset moldingsPolymer Engineering & Science, 1979
- The effect of deformation and thermoset cure on heat conduction in a chopped-fiber reinforced polyester during compression moldingInternational Journal of Heat and Mass Transfer, 1979
- Curing of highly reactive polyester resin under pressure: Kinetic studies by differential scanning calorimetryJournal of Applied Polymer Science, 1975
- Calorimetric investigation of polymerization reactions. IV. Curing reaction of polyester fumarate with styreneJournal of Polymer Science Part A-1: Polymer Chemistry, 1970
- Calorimetric investigation of polymerization reactions. II. Copolymerization of diethyl fumarate with styreneJournal of Polymer Science Part A-1: Polymer Chemistry, 1969
- Copolymerization. IV. Effects of Temperature and Solvents on Monomer Reactivity RatiosJournal of the American Chemical Society, 1948