Low-Reynolds-number turbulent boundary layers
- 1 September 1991
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 230, 1-44
- https://doi.org/10.1017/s0022112091000691
Abstract
An investigation was undertaken to improve our understanding of low-Reynolds-number turbulent boundary layers flowing over a smooth flat surface in nominally zero pressure gradients. In practice, such flows generally occur in close proximity to a tripping device and, though it was known that the flows are affected by the actual low value of the Reynolds number, it was realized that they may also be affected by the type of tripping device used and variations in free-stream velocity for a given device. Consequently, the experimental programme was devised to investigate systematically the effects of each of these three factors independently. Three different types of device were chosen: a wire, distributed grit and cylindrical pins. Mean-flow, broadband-turbulence and spectral measurements were taken, mostly for values of Rθ varying between about 715 and about 2810. It was found that the mean-flow and broadband-turbulence data showed variations with Rθ, as expected. Spectra were plotted using scaling given by Perry, Henbest & Chong (1986) and were compared with their models which were developed for high-Reynolds-number flows. For the turbulent wall region, spectra showed reasonably good agreement with their model. For the fully turbulent region, spectra did show some appreciable deviations from their model, owing to low-Reynolds-number effects. Mean-flow profiles, broadband-turbulence profiles and spectra were found to be affected very little by the type of device used for Rθ ≈ 1020 and above, indicating an absence of dependence on flow history for this Rθ range. These types of measurements were also compared at both Rθ ≈ 1020 and Rθ ≈ 2175 to see if they were dependent on how Rθ was formed (i.e. the combination of velocity and momentum thickness used to determine Rθ). There were noticeable differences for Rθ ≈ 1020, but these differences were only convincing for the pins, and there was a general overall improvement in agreement for Rθ ≈ 2175.Keywords
This publication has 13 references indexed in Scilit:
- Structure of a turbulent boundary layer on a concave surfaceJournal of Fluid Mechanics, 1988
- Direct simulation of a turbulent boundary layer up to Rθ = 1410Journal of Fluid Mechanics, 1988
- An experimental study of the turbulence structure in smooth- and rough-wall boundary layersJournal of Fluid Mechanics, 1987
- A theoretical and experimental study of wall turbulenceJournal of Fluid Mechanics, 1986
- The structure of turbulent boundary layers at low Reynolds numbersJournal of Fluid Mechanics, 1982
- A note on von Kármán's constant in low Reynolds number turbulent flowsJournal of Fluid Mechanics, 1972
- Characteristics of turbulent boundary layers at low Reynolds numbers with and without transpirationJournal of Fluid Mechanics, 1970
- Calibration of the Preston tube and limitations on its use in pressure gradientsJournal of Fluid Mechanics, 1965
- The minimum Reynolds number for a turbulent boundary layer and the selection of a transition deviceJournal of Fluid Mechanics, 1957
- The law of the wake in the turbulent boundary layerJournal of Fluid Mechanics, 1956