Experimental study of wire electrical discharge machining of AISI D5 tool steel
- 1 May 2004
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 148 (3) , 362-367
- https://doi.org/10.1016/j.jmatprotec.2004.02.048
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- Experimental investigation of effects of cutting parameters on surface roughness in the WEDM processInternational Journal of Machine Tools and Manufacture, 2000
- An experimental study on electro-discharge machining and polishing of high strength copper–beryllium alloysJournal of Materials Processing Technology, 2000
- Influence of EDM pulse energy on the surface integrity of martensitic steelsJournal of Materials Processing Technology, 1998
- A study on the machining-parameters optimization of wire electrical discharge machiningJournal of Materials Processing Technology, 1997
- On the effect of electrodischarge machining parameters on the fatigue life of AISI D6 tool steelJournal of Materials Processing Technology, 1997
- Parametric optimization and surface characterization of wire electrical discharge machining processPrecision Engineering, 1997
- Analysis and optimization of parameter combinations in wire electrical discharge machiningInternational Journal of Production Research, 1991
- Study of wire electrical discharge machined surface characteristicsJournal of Materials Processing Technology, 1991
- The Surface Integrity of a Die Steel after Electrodischarge Machining: 2 Residual Stress DistributionSurface Engineering, 1991
- Macroscopic and microscopic phenomena of electro-discharge machined steel surfaces: An experimental investigationJournal of Materials Processing Technology, 1987