Flow visualization for injection molding of polyethylene and polystyrene melts
- 1 March 1974
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 14 (3) , 212-222
- https://doi.org/10.1002/pen.760140310
Abstract
No abstract availableKeywords
This publication has 36 references indexed in Scilit:
- A study of bicomponent coextrusion of molten polymersJournal of Applied Polymer Science, 1973
- Gel permeation and thin‐layer chromatographic characterization and solution properties of butadiene and styrene homopolymers and copolymersJournal of Applied Polymer Science, 1972
- Some aspects of orientation in injection molded objectsPolymer Engineering & Science, 1972
- The injection molding of thermoplastics part II: Experimental test of the modelPolymer Engineering & Science, 1972
- The injection molding of thermoplastics part I: Theoretical modelPolymer Engineering & Science, 1972
- The development of the velocity field in polymer melts in a reservoir approaching a capillary dieJournal of Applied Polymer Science, 1971
- Entrance- and Exit-Correction in Capillary Flow of Molten PolymersTransactions of the Society of Rheology, 1971
- Polymer Melt Flow Instabilities in Extrusion: Investigation of the Mechanism and Material and Geometric VariablesTransactions of the Society of Rheology, 1971
- Flow of Polyethylene into a CapillaryJournal of Applied Physics, 1960
- Some Applications of Photography1Nature, 1891