Aspects of basin inversion in southern Britain
- 1 March 1993
- journal article
- Published by Geological Society of London in Journal of the Geological Society
- Vol. 150 (2) , 311-322
- https://doi.org/10.1144/gsjgs.150.2.0311
Abstract
The Wessex Basin of southern England, a Permian to Cretaceous extensional basin, can be structurally divided into a set of constituent asymmetrical graben, bounded by major E–W-trending zones of en echelon syn-depositional normal faults. The graben were inverted in late Cretaceous and Tertiary times by compressive stresses oriented roughly north–south. Inversion structures fall into two related categories. Regional upwarps overlie earlier graben depocentres and were formed by bulk shortening of the graben-fill. Superimposed upon and geographically delimiting the regional upwarps, are roughly east-west trending linear zones of en echelon inversion structures. These coincide with the earlier graben-bounding faults and typically have the form of monoclinal or periclinal flexures each underlain by a partially reversed normal fault. The linear reverse fault/monocline inversion structures were a relatively inefficient method of basin shortening. Because upper crustal faults in the region steepen upward markedly, reversal of these faults under compression resulted in a shortening discrepancy at shallow depths. Locally, particularly in south Dorset, this was overcome by bucklefolding and low-angle reverse faulting which increased the amount of shortening attainable across the linear inversion structures. Elsewhere however, the shortening discrepancy was accommodated by bulk shortening and regional upwarp of the graben sedimentary-fill. This occurred preferentially in those graben containing young, poorly lithified and therefore weak sediments. Thus the early Cretaceous depocentres of the Weald and Channel basins were strongly upwarped, with axial uplifts of over 1000 m. Conversely, graben having older, more lithified sequences suffered little regional upwarp, shortening primarily by fault reversal along the linear inversion structures. The amount of crustal shortening which accompanied inversion was considerably less than the earlier crustal extension.This publication has 21 references indexed in Scilit:
- Geological evidence for intra-Jurassic faulting in the Wessex Basin and its marginsJournal of the Geological Society, 1991
- Tertiary structures and hydrocarbon entrapment in the Weald Basin of southern EnglandGeological Society, London, Special Publications, 1990
- IntroductionGeological Society, London, Special Publications, 1989
- The structure and evolution of the Wessex Basin, southern England: an example of inversion tectonicsTectonophysics, 1987
- Compressional intra-plate deformations in the Alpine foreland—an introductionTectonophysics, 1987
- The Sticklepath-Lustleigh fault zone: Tertiary sinistral reactivation of a Variscan dextral strike-slip faultJournal of the Geological Society, 1986
- Seismic Characteristics and Identification of Negative Flower Structures, Positive Flower Structures, and Positive Structural InversionAAPG Bulletin, 1985
- Crustal structure beneath southern England from deep seismic reflection profilesJournal of the Geological Society, 1983
- The structural development of the Wessex BasinJournal of the Geological Society, 1982
- Eocene sedimentation and tectonics in the Hampshire BasinJournal of the Geological Society, 1982