Corrosion of metals in the tropics
- 1 September 1955
- journal article
- research article
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 5 (9) , 437-467
- https://doi.org/10.1002/jctb.5010050901
Abstract
The atmospheric corrosion of a few common metals has been studied at more than twenty sites in Nigeria and at some others under various conditions of atmospheric humidity and salinity. Contrary to general belief, corrosion is not generally higher under tropical conditions than in temperate climates. Where there is no industrial pollution, the governing factor is airborne salt and while in very saline atmospheres steel may corrode as much as 8 g./dm.2/month, in very humid areas free from high salinity the rate may be less than 0.1. The rate of corrosion of ferrous metals varies little between wet and dry seasons or between day and night. Atmospheric salinity has been measured by various methods and at many places; the corrosion of ferrous metals and zinc is proportional to the rate of deposit of salt on a damp textile surface. The corrosion of steel in tropical tidal waters is twice as fast in tidal as in continuous immersion, and in the former case can be as high as 12 g. dm.2/ month.Keywords
This publication has 8 references indexed in Scilit:
- The Concentration of Contaminant Alkali Salts in Ground Level AirScience, 1953
- The effect of climate and atmospheric pollution on corrosionJournal of Chemical Technology & Biotechnology, 1953
- ATMOSPHERIC SALT PARTICLES AND RAINDROPSJournal of Meteorology, 1952
- Determination of Chloride in Water-Addendum. Preparation and Effect of Mercuric Nitrate ReagentAnalytical Chemistry, 1950
- The Cascade Impactor: An Instrument for Sampling Coarse AerosolsJournal of Scientific Instruments, 1945
- Factors Effecting Vegetational Zonation on Coastal DunesEcology, 1942
- The determination of size distribution in smokesTransactions of the Faraday Society, 1936
- A laboratory study of the atmospheric corrosion of metals. Part II.—Iron: the primary oxide film. Part III.—The secondary product or rust (influence of sulphur dioxide, carbon dioxide, and suspended particles on the rusting of iron)Transactions of the Faraday Society, 1935