The influence of foreign gas injection and slot geometry on film cooling effectiveness
- 1 August 1969
- journal article
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 12 (8) , 935-951
- https://doi.org/10.1016/0017-9310(69)90156-2
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Film Cooling Slots: The Importance of Lip Thickness and Injection AngleJournal of Mechanical Engineering Science, 1969
- The Effect of Slot Height and Slot-Turbulence Intensity on the Effectiveness of the Uniform Density, Two-Dimensional Wall JetJournal of Heat Transfer, 1968
- The dependence of the impervious wall effectiveness of a two-dimensional wall-jet on the thickness of the upper lip boundary layerInternational Journal of Heat and Mass Transfer, 1967
- On the use of a boundary-layer model for correlating film cooling dataInternational Journal of Heat and Mass Transfer, 1967
- Film cooling with helium injection into an incompressible air flowInternational Journal of Heat and Mass Transfer, 1966
- Rapid Analysis by Gas Chromatography. V. A Catharometer with Rapid ResponseJournal of Chromatographic Science, 1966
- A note on the use of a boundary-layer model for correlating film-cooling dataInternational Journal of Heat and Mass Transfer, 1965
- Turbulent transport properties for axisymmetric heterogeneous mixingAIAA Journal, 1964
- Effects of Initial Boundary-Layer Thickness on a Tangential Injection SystemJournal of Heat Transfer, 1960
- Turbulent Boundary Layers in Adverse Pressure GradientsJournal of the Aeronautical Sciences, 1954