Residual stresses in turning: Part I: Influence of process parameters
- 5 August 2004
- journal article
- Published by Elsevier
- Vol. 160 (2) , 221-228
- https://doi.org/10.1016/j.jmatprotec.2004.06.012
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Residual stress analysis in orthogonal machining of standard and resulfurized AISI 316L steelsJournal of Materials Processing Technology, 1999
- Residual Stresses and Surface Roughness in TurningJournal of Engineering Materials and Technology, 1999
- Machining-Induced Residual Stress: Experimentation and ModelingJournal of Manufacturing Science and Engineering, 1999
- A method of modeling residual stresses in superfinish hard turningWear, 1998
- Surface residual stresses in machined austenitic stainless steelWear, 1996
- Effect of thermal load and mechanical load on the residual stress of a machined workpieceInternational Journal of Mechanical Sciences, 1991
- The Effect of Hardness on Residual Stresses in Orthogonal Machining of AISI 4340 SteelJournal of Engineering for Industry, 1990
- Residual Stresses — Measurement and Causes in Machining ProcessesCIRP Annals, 1982
- The Mechanical State of the Sublayer of a Surface Generated by Chip-Removal Process—Part 2: Cutting With a Tool With Flank WearJournal of Engineering for Industry, 1976
- The Mechanical State of the Sublayer of a Surface Generated by Chip-Removal Process—Part 1: Cutting With a Sharp ToolJournal of Engineering for Industry, 1976