Stretching limits in sheet metals: In-plane versus out-of-plane deformation
- 1 October 1974
- journal article
- mechanical behavior
- Published by Springer Nature in Metallurgical Transactions
- Vol. 5 (10) , 2161-2164
- https://doi.org/10.1007/bf02643929
Abstract
No abstract availableKeywords
This publication has 8 references indexed in Scilit:
- Influence of the plastic properties of a material on the forming limit diagram for sheet metal in tensionInternational Journal of Mechanical Sciences, 1973
- The influence of back pressure on the point of instability of axisymmetric shells deformed by fluid pressureInternational Journal of Mechanical Sciences, 1973
- On quasistatic axisymmetrical stretch formingInternational Journal of Mechanical Sciences, 1970
- Plastic deformation and failure of thin elliptical diaphragmsInternational Journal of Mechanical Sciences, 1970
- The deformation and failure of a biaxially stretched sheetMetallurgical Transactions, 1970
- Large Plastic Deformation of a Circular Sheet Caused by Punch StretchingJournal of Applied Mechanics, 1970
- On the plastic bulging of a circular diaphragm by hydrostatic pressureJournal of the Mechanics and Physics of Solids, 1969
- Limit strains in the processes of stretch-forming sheet metalInternational Journal of Mechanical Sciences, 1967