Flow of polymers with pressure‐dependent viscosity in injection molding dies
- 1 May 1979
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 19 (7) , 469-473
- https://doi.org/10.1002/pen.760190702
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- Mold‐filling studies for the injection molding of thermoplastic materials. Part II: The transient flow of plastic materials in the cavities of injection‐molding diesPolymer Engineering & Science, 1975
- Mold‐filling studies for the injection molding of thermoplastic materials. Part I: The flow of plastic materials in hot‐ and cold‐walled circular channelsPolymer Engineering & Science, 1975
- Flow analysis network (FAN)—A method for solving flow problems in polymer processingPolymer Engineering & Science, 1974
- Simulation of the mold‐filling processPolymer Engineering & Science, 1974
- A numerical simulation of the cavity filling process with PVC in injection moldingPolymer Engineering & Science, 1973
- The injection molding of thermoplastics part II: Experimental test of the modelPolymer Engineering & Science, 1972
- The injection molding of thermoplastics part I: Theoretical modelPolymer Engineering & Science, 1972
- Analysis of the melt viscosity and glass transition of polystyreneJournal of Polymer Science Part A-2: Polymer Physics, 1968
- The thermodynamic analysis of the effect of pressure on the glass temperature of polystyrenePolymer, 1966
- The significance of slip of polymer melt flowPolymer Engineering & Science, 1966