Modern sedimentation and hydrology in Lake Tyrrell, Victoria
- 1 April 1982
- journal article
- research article
- Published by Taylor & Francis in Journal of the Geological Society of Australia
- Vol. 29 (1-2) , 159-175
- https://doi.org/10.1080/00167618208729202
Abstract
Lake Tyrrell is a large ephemeral salt lake, the level of which is controlled by climate and groundwater. Up to a metre of water fills the basin during the wetter and cooler winter season, but evaporates during the summer, precipitating up to 10 cm of halite. Each year essentially the same pool of ions is redissolved by this annual freshening. The small percentage of gypsum precipated (< 2%) in the surface salt crust reflects the low calcium content of the brine which, in turn, is a function of the negligible net discharge of calcium from the groundwater system. The small influx of fine‐grained clastic sediment to the lake floor comes from surface runoff, wind, and reworking of older sediment from the shoreline. The Lake Tyrrell basin lies in a setting in which three different groundwater types, identified by distinct salinities, interact with surface waters. A refluxing cycle that goes from discharging groundwater at the basin margin, to surface evaporation on the lake floor, to recharge through the floor of the lake, controls the major chemical characteristics of the basin. In this process, salts are leached downward from the lake floor to join a brine pool below the lake. This provides an outlet from the lake, especially under conditions that have been both drier and wetter than those of today. Enhanced discharge occurs under drier conditions, when the enclosing regional groundwater divide is lowered, whereas a rise in lake level increases the hydraulic head over that of the sub‐surface brine and promotes an increase in brine loss from the lake. Sulphate‐reducing bacteria in a zone of black sulphide‐rich mud beneath the salt crust help prevent gypsum from being incorporated into the recent sedimentary record. However, below the upper 5 to 10 cm zone of bacterial activity, discoidal gypsum is being precipitated within the mud from the groundwater. These crystals have grown by displacing the mud and typically “float” in a clay matrix; in some zones, they form concentrations exceeding 50% of the sediment. The occasional laminae of more prismatic gypsum that occur within the upper metre of mud have crystallised from surface brines. The scarcity of these comparatively pure prismatic‐crystal concentrations probably is a function of unfavourable chemical conditions in the lake brine and of the role that sulphate‐reducing bacteria have played.Keywords
This publication has 15 references indexed in Scilit:
- Aridity in Australia: Age, origins and expression in aeolian landforms and sedimentsPublished by Elsevier ,2003
- Geochemistry of Evaporitic Lacustrine DepositsAnnual Review of Earth and Planetary Sciences, 1980
- Gypsum-organic interactions in natural seawater: Effect of organics on precipitation kinetics and crystal morphologyMarine Chemistry, 1978
- Biological sulphate reduction in carbonate sediments of a coral reefMarine and Freshwater Research, 1976
- CONTROLS AND CONSEQUENCES OF SULFATE REDUCTION RATES IN RECENT MARINE SEDIMENTSSoil Science, 1975
- A comparison of calcium sulfate dihydrate grown in clay gels and in sodium silicate gelsJournal of Crystal Growth, 1974
- An investigation of the factors which affect the size and growth rates of the habit faces of gypsumJournal of Crystal Growth, 1973
- Growth of CaCO3 and CaSO4 · 2H2O crystals in gelsJournal of Crystal Growth, 1971
- An Occurrence of Gypsum in Southwest TexasJournal of Sedimentary Research, 1955
- Recovery heat in muscleProceedings of the Royal Society of London. B. Biological Sciences, 1939