Novel operation and control modes for series-resonant converters
- 1 May 1985
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. IE-32 (2) , 150-157
- https://doi.org/10.1109/tie.1985.350186
Abstract
A series-resonant converter (SRC) able to generate an output voltage either lower or higher than the source voltage is described. Moreover, a novel control scheme is presented which renders two degrees of freedom for control and which guarantees symmetrical steady-state waveforms in all operation modes. Both the average resonant current as well as the peak voltage of the resonant capacitor can be controlled independently. Special attention is given to an operation mode which facilitates converter operation when the output voltages approximately equal the source voltage (q approx equal to 1). Test results are presented of both controller and converter.Keywords
This publication has 8 references indexed in Scilit:
- DC-to-AC Series-Resonant Converter System with High Internal Frequency Generating Synthesized Waveforms for Multikilowatt Power LevelsIEEE Transactions on Power Electronics, 1986
- A New Integral Pulse Module for the Series-Resonant ConverterIEEE Transactions on Industrial Electronics, 1984
- Modeling the Full-Bridge Series-Resonant Power ConverterIEEE Transactions on Aerospace and Electronic Systems, 1982
- A Multikilowatt Polyphase AC/DC Converter with Reversible Power Flow and without Passive Low-Frequency FiltersIEEE Transactions on Industrial Electronics and Control Instrumentation, 1981
- A Doublesided CycloconverterIEEE Transactions on Industrial Electronics and Control Instrumentation, 1981
- An Improved Method of Resonant Current Pulse Modulation for Power ConvertersIEEE Transactions on Industrial Electronics and Control Instrumentation, 1976
- A Controllable Secondary Multikilowatt DC Current Source With Constant Maximum Power Factor in its Three-Phase Supply LineIEEE Transactions on Industrial Electronics and Control Instrumentation, 1976
- A Method of Resonant Current Pulse Modulation for Power ConvertersIEEE Transactions on Industrial Electronics and Control Instrumentation, 1970