Coupled analysis of injection molding filling and fiber orientation, including in‐plane velocity gradient effect
- 1 December 1996
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 17 (6) , 859-872
- https://doi.org/10.1002/pc.10679
Abstract
No abstract availableKeywords
This publication has 24 references indexed in Scilit:
- Fiber orientation and mechanical properties of short‐fiber‐reinforced injection‐molded composites: Simulated and experimental resultsPolymer Composites, 1993
- Fiber orientation in simple injection moldings. Part I: Theory and numerical methodsPolymer Composites, 1992
- Numerical prediction of fiber orientation in injection moldingPolymer Engineering & Science, 1992
- Flow regimes for fiber suspensions in narrow gapsJournal of Non-Newtonian Fluid Mechanics, 1991
- Prediction of fiber orientation in injection molded parts of short‐fiber‐reinforced thermoplasticsPolymer Engineering & Science, 1990
- Numerical prediction of three‐dimensional fiber orientation in Hele‐Shaw flowsPolymer Engineering & Science, 1990
- Simulation of non-recirculating flows of dilute fiber suspensionsJournal of Non-Newtonian Fluid Mechanics, 1990
- A numerical solution for the flow of dilute fiber suspensions through an axisymmetric contractionJournal of Non-Newtonian Fluid Mechanics, 1990
- The flow of fiber suspensions in complex geometriesJournal of Non-Newtonian Fluid Mechanics, 1988
- Isothermal extrusion of non-dilute fiber suspensionsJournal of Non-Newtonian Fluid Mechanics, 1987