Origin of thick, high‐velocity igneous crust along the U.S. East Coast Margin
- 10 June 1995
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 100 (B6) , 10077-10094
- https://doi.org/10.1029/95jb00924
Abstract
Recent seismic results on the U.S. East Coast continental margin show that the zone between rifted continental and normal oceanic crust consists of thick (up to 25 km), high seismic velocity (νp of 7.2–7.3 km s−1) crust, interpreted as mafic igneous rocks emplaced during Triassic/Jurassic continental rifting. The total volume of igneous rocks in this zone, which we call the East Coast Margin Igneous Province (ECMIP), may be as much as 2.7 × 106 km3, placing the ECMIP among the world's large igneous provinces. We constrain the composition and origin of the thick, igneous crust by using a compilation of laboratory measurements to predict P wave velocities for rocks with the compositions of liquids produced by partial melting of mantle rocks. The high‐velocity crust was produced from partial melting of mantle peridotite, with smaller melt fractions (<10%) but at higher average pressures (≥2.0 GPa) than beneath normal mid‐ocean ridges. This requires higher than normal asthenospheric potential temperatures during rifting and a lid of lithosphere above upwelling asthenosphere to limit the minimum pressure of melting. Production of thick igneous crust at small melt fractions requires that the vertical flux of asthenosphere during rifting exceeded the lateral flux of lithosphere due to extension; that is, mantle “upwelling” was more rapid than lithospheric “spreading.” Thick igneous crust is strongly asymmetrical, extending up to 2000 km along the margin but only for about 80–100 km seaward. The rapid seaward transition to oceanic crust with normal thickness and seismic velocity implies that the thermal anomaly and relatively rapid upwelling lasted for only 5–8 m.y. Moreover, there is no crustal thickness anomaly in the Central Atlantic, in contrast to the North Atlantic where the influence of the Iceland plume created thick crust in a belt spanning the ocean from Greenland to the Faeroes Islands. These factors seem to preclude formation of thick igneous crust in response to a deep‐seated mantle plume. The ECMIP may have formed when high upper mantle temperatures induced asthenospheric upwelling. Magmatism and seafloor spreading dissipated the thermal anomaly in the upper mantle, after which normal oceanic crust formed along the Mid‐Atlantic Ridge.Keywords
This publication has 108 references indexed in Scilit:
- Hotspot tracks and the early rifting of the AtlanticPublished by Elsevier ,2003
- Experiments on flow focusing in soluble porous media, with applications to melt extraction from the mantleJournal of Geophysical Research, 1995
- Focused melt flow and localized deformation in the upper mantle: Juxtaposition of replacive dunite and ductile shear zones in the Josephine peridotite, SW OregonJournal of Geophysical Research, 1995
- A dynamic model of extension in the Baltimore Canyon Trough RegionTectonics, 1992
- Magmatism and rift margin evolution: Evidence from northwest AustraliaGeology, 1992
- Seismic properties of rocks from an exposure of extended continental crust—new laboratory measurements from the Ivrea ZoneTectonophysics, 1990
- Velocity anisotropy and shear-wave splitting in rocks from the mylonite belt along the Insubric Line (Ivrea Zone, Italy)Earth and Planetary Science Letters, 1990
- An experimental method for directly determining the interconnectivity of melt in a partially molten systemGeophysical Research Letters, 1988
- A model of velocity structure beneath Calabria, southern Italy, based on laboratory dataEarth and Planetary Science Letters, 1988
- Anhydrous partial melting of MORB pyrolite and other peridotite compositions at 10 kbar: Implications for the origin of primitive MORB glassesTschermaks Mineralogische und Petrographische Mitteilungen, 1987