The Draper Loom in New England Textiles, 1894–1914: A Study of Diffusion of an Innovation
- 1 September 1966
- journal article
- research article
- Published by Cambridge University Press (CUP) in The Journal of Economic History
- Vol. 26 (3) , 320-347
- https://doi.org/10.1017/s0022050700068406
Abstract
The power loom, which had almost completely replaced the hand loom in America by 1860, remained the center of continuous technical development until about 1880. The main effects of the improvements were to increase the speed at which the looms could be operated and to decrease the amount of attention a weaver had to devote to a single loom. Estimates of plain looms tended by one weaver range from four to twelve; six is the most frequently cited figure, based upon the census report for 1880. The number of looms a weaver could tend was limited because of the frequent need—at least once every eight minutes, or about one hundred times a day—for him to stop the loom to place a new bobbin of yarn in the shuttle. With the number of looms per weaver set at about six and allowing for certain improvements in carding and spinning, weaving costs formed at least half of the total labor cost of manufacturing textile fabric.Keywords
This publication has 5 references indexed in Scilit:
- The Economics of New EnglandPublished by Harvard University Press ,1952
- The Whitin Machine Works Since 1831Published by Harvard University Press ,1950
- Pepperell’s ProgressPublished by Harvard University Press ,1948
- The Cotton Textile Industry of Fall River • MassachusettsPublished by Columbia University Press ,1944
- The Decline of a Cotton Textile CityPublished by Columbia University Press ,1944