Oligomeric States of the HIV-1 Integrase As Measured by Time-Resolved Fluorescence Anisotropy
- 14 July 2000
- journal article
- research article
- Published by American Chemical Society (ACS) in Biochemistry
- Vol. 39 (31) , 9275-9284
- https://doi.org/10.1021/bi000397j
Abstract
Self-assembly properties of HIV-1 integrase were investigated by time-resolved fluorescence anisotropy using tryptophanyl residues as a probe. From simulation analyses, we show that suitable photon counting leads to an accurate determination of long rotational correlation times in the range of 20−80 ns, permitting the distinction of the monomer, dimer, and tetramer from higher oligomeric forms of integrase. The accuracy of correlation times higher than 100 ns is too low to distinguish the octamer from other larger species. The oligomeric states of the widely used detergent-solubilized integrase were then studied in solution under varying parameters known to influence the activity. In the micromolar range, integrase exists as high-order multimers such as an octamer and/or aggregates and a well-defined tetramer, at 25 and 35 °C, respectively. However, integrase is monomeric at catalytically active concentrations (in the sub-micromolar range). Detergents (NP-40 and CHAPS) and divalent cation cofactors (Mg2+ and Mn2+) have a clear dissociative effect on the high multimeric forms of integrase. In addition, we observed that Mg2+ and Mn2+ have different effects on both the oligomeric state and the conformation of the monomer. This could explain in part why these two metal cations are not equivalent in terms of catalytic activity in vitro. In contrast, addition of Zn2+ stimulates dimerization. Interestingly, this role of Zn2+ in the multimerization process was evident only in the presence of Mg2+ which by itself does not induce oligomerization. Finally, it is highly suggested that the presence of detergent during the purification procedure plays a negative role in the proper self-assembly of integrase. Accordingly, the accompanying paper [Leh, H., et al. (2000) Biochemistry39, 9285−9294] shows that a detergent-free integrase preparation has self-assembly and catalytic properties different from those of the detergent-solubilized enzyme.Keywords
This publication has 24 references indexed in Scilit:
- Molecular Dynamics of Microbial Lipases as Determined from Their Intrinsic Tryptophan FluorescenceBiophysical Journal, 1999
- Structural Determinants of Metal-induced Conformational Changes in HIV-1 IntegrasePublished by Elsevier ,1998
- Sequence specificity of viral end DNA binding by HIV-1 integrase reveals critical regions for protein-DNA interactionThe EMBO Journal, 1998
- Crystal structures of the catalytic domain of HIV-1 integrase free and complexed with its metal cofactor: high level of similarity of the active site with other viral integrases 1 1Edited by R. HuberJournal of Molecular Biology, 1998
- Critical contacts between HIV-1 integrase and viral DNA identified by structure-based analysis and photo-crosslinkingThe EMBO Journal, 1997
- [4] Time-resolved room temperature tryptophan phosphorescence in proteinsPublished by Elsevier ,1997
- Intrinsic Fluorescence Properties and Structural Analysis of p13 from Schizosaccharomyces pombePublished by Elsevier ,1996
- An Essential Interaction between Distinct Domains of HIV-1 Integrase Mediates Assembly of the Active MultimerJournal of Biological Chemistry, 1995
- Temperature dependence of fluorescence lifetime distributions in 1,3-di(1-pyrenyl)propane with the maximum entropy methodThe Journal of Physical Chemistry, 1989
- Segmental flexibility in an antibody moleculeJournal of Molecular Biology, 1970