Indentation cracking in soda-lime glass and Ni-Zn ferrite under Knoop and conical indenters and residual stress measurements
- 1 May 1993
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine A
- Vol. 67 (5) , 1187-1218
- https://doi.org/10.1080/01418619308224767
Abstract
The indentation cracking behaviour of thermally tempered and of annealed soda-lime glass blocks has been studied experimentally. The indenters were a Knoop pyramidal diamond and a tungsten carbide cone of apex angle 90d'. They were loaded normally on to the flats and particular attention was paid to the evolution (i.e. initiation and growth) of the median and lateral cracks generated under the indenters. Under the Knoop indenter, a half-penny-shaped median crack formed in both the tempered and the annealed soda-lime blocks during loading to sufficiently high loads. During unloading, the median crack grew in length at the indented surface while its depth appeared to decrease (not heal). Lateral cracks, both the subsurface and the shallow types, formed during unloading. The shallow surface laterals always formed at close to complete unloading and caused chipping of the surface. The surface extent of the lateral cracking extended beyond the surface traces of the median cracks in the thermally tempered glass blocks. With the conical indenter, one or more approximately full-penny-shaped median cracks formed in the tempered glass blocks during loading to sufficiently high loads. During unloading, the median cracks broke through to the surface becoming like half-pennies. In the annealed glass blocks, the median cracks broke through to the surface during loading to sufficiently high loads. Otherwise, the evolution of median and lateral cracks was similar to that in the case of the Knoop indenter. With all the pointed indenters, namely Knoop, cone and Vickers, when the maximum load was not sufficiently high, no cracks formed during loading (sometimes no cracks formed even at loads of 100-200 N), but median cracks were observed to form during unloading. High-speed framing photography has been unable to resolve the location of initiation of the unloading median cracks. Observations of unloading median cracks under quasistatic indentations have so far not been reported.Keywords
This publication has 27 references indexed in Scilit:
- Quasi-static indentation cracking of thermally tempered soda-lime glass with spherical and Vickers indentersPhilosophical Magazine A, 1990
- Direct Observation and Analysis of Indentation Cracking in Glasses and CeramicsJournal of the American Ceramic Society, 1990
- Factors Influencing Residual Surface Stresses due to a Stress‐Induced Phase BansformationJournal of the American Ceramic Society, 1983
- The response of solids to elastic/plastic indentation. I. Stresses and residual stressesJournal of Applied Physics, 1982
- The area of contact between a small sphere and a flat surfacePhilosophical Magazine A, 1981
- Elastic/Plastic Indentation Damage in Ceramics: The Median/Radial Crack SystemJournal of the American Ceramic Society, 1980
- Micromechanics of crack nucleation during indentationsJournal of Materials Science, 1979
- The influence of multiaxial stress states, stress gradients and elastic anisotropy on the evaluation of (Residual) stresses by X-raysJournal of Applied Crystallography, 1979
- Chemical Strengthening of Polycrystalline AluminaJournal of the American Ceramic Society, 1968
- VI. The phenomena of rupture and flow in solidsPhilosophical Transactions of the Royal Society A, 1921