SPECT COMPTON-SCATTERING CORRECTION BY ANALYSIS OF ENERGY-SPECTRA

  • 1 February 1988
    • journal article
    • research article
    • Vol. 29  (2) , 195-202
Abstract
The hypothesis that energy spectra at individual spatial locations in single photon emission computed tomographic projection images can be analyzed to separate the Compton-scattered component from the unscattered component is tested indirectly. An axially symmetric phantom consisting of a cylinder with a sphere is imaged with either the cylinder or the sphere containing 99mTc. An iterative peak-erosion algorithm and a fitting algorithm are given and employed to analyze the acquired spectra. Adequate separation into an unscattered component and a Compton-scattered component is judged on the basis of filtered-backprojection reconstruction of corrected projections. In the reconstructions, attenuation correction is based on the known geometry and the total attenuation cross section for water. An independent test of the accuracy of separation is not made. For both algoriothms, reconstructed slices for the cold-sphere, hot-surround phantom have the correct shape as confirmed by simulation results that take into account the measured dependence of system resolution on depth. For the inverse phantom, a hot sphere in a cold surround, quantitative results with the fitting algorithm are accurate but with a particular number of iterations of the erosion algorithm are less good. (A greater number of iterations would improve the 26% error with the algorithm, however). These preliminary results encourage us to believe that a method for correctiong for Compton-scattering in a wide variety of objects can be found, thus helping to achieve quantitative SPECT.