A Study of the Drilling Process

Publisher Website
Google Scholar
Abstract
Drilling is a complex three dimensional cutting process yet it is possible to simulate the action of a two flute twist drill with two dimensional models provided consideration is given to the influence of the feed velocity on the cutting geometry at the drill point. Two models of chip formation and an indentation model are developed to simulate the action of the drill point. From these models equations are derived for the prediction of total torque and thrust given the cutting conditions, drill geometry, and an empirical factor which is related to the work material. Computed values of torque and thrust are shown to compare favorably with those obtained from drilling tests on an 0.45 percent C steel. The shape and magnitude of the wear zone about the chisel edge is estimated and it is shown that the observed finite thrust force as the feed rate approaches zero can be attributed to the “cutting” action of the chisel edge.

This publication has 0 references indexed in Scilit: