Phase morphology of injection‐molded blends of nylon‐6 and polyethylene and comparison with compression molding
- 1 January 1991
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 31 (2) , 76-83
- https://doi.org/10.1002/pen.760310204
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- An investigation of instability of phase morphology of blends of nylons with polyethylenes and polystyrenes and effects of compatibilizing agentsPolymer Engineering & Science, 1988
- Present and Future Trends in Polymer Blends Technology**International Polymer Processing, 1987
- Properties and morphology of some injection-molded polycarbonate-styrene acrylonitrile copolymer blendsPolymer Engineering & Science, 1987
- Skin‐Core morphology and failure of injection‐molded specimens of impact‐modified polypropylene blendsPolymer Engineering & Science, 1987
- Polyethylene‐polycarbonate blends: Interface modification, phase morphology and measurement of orientation development during cast film and tubular extrusion by infrared dichroismPolymer Engineering & Science, 1986
- Development of phase morphology in incompatible polymer blends during mixing and its variation in extrusionPolymer Engineering & Science, 1984
- High density polyethylene/polystyrene blends: Phase distribution morphology, rheological measurements, extrusion, and melt spinning behaviorJournal of Applied Polymer Science, 1984
- Polypropylene/nylon 6 blends: Phase distribution morphology, rheological measurements, and structure development in melt spinningJournal of Applied Polymer Science, 1983
- Processing of polyolefin blendsPolymer Engineering & Science, 1981
- Phase Morphology of High-Impact-Strength Blends of EPDM and Polypropylene. Knit-Line BehaviorRubber Chemistry and Technology, 1977