Maximum-Likelihood Detection of Unresolved Radar Targets and Multipath
- 1 November 1974
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. AES-10 (6) , 821-829
- https://doi.org/10.1109/taes.1974.307890
Abstract
Interference in the form of multipath or uncooperative targets can seriously degrade the angle-of-arrival estimation accuracy of mutiplebeam processors. In this paper, the generalized likelihood ratio test is used to derive a test to detect the presence of interference for multiple beam processors. The detector performance is then analyzed in detail with respect to its dependence on signal-to-noise ratio (SNR), signal-to-interference ration (SIR), and on the relative phase between the target and interfering signals. It is shown that good detection performance can be obtained unless the phase difference between the target and interference signals is either in or out of phase.Keywords
This publication has 9 references indexed in Scilit:
- Azimuth-Elevation Estimation Performance of a Spatially Dispersive ChannelIEEE Transactions on Aerospace and Electronic Systems, 1974
- Multipath Angle Error Reduction Using Multiple-Target MethodsIEEE Transactions on Aerospace and Electronic Systems, 1971
- Complex Indicated Angles Applied to Unresolved Radar Targets and MultipathIEEE Transactions on Aerospace and Electronic Systems, 1971
- Detection and parameter estimation in an amplitude-comparison monopulse radarIEEE Transactions on Information Theory, 1969
- Angular Tracking of Two Closely Spaced Radar TargetsIEEE Transactions on Aerospace and Electronic Systems, 1968
- The resolution of closely spaced signalsIEEE Transactions on Information Theory, 1968
- Radar Resolution of Closely Spaced TargetsIRE Transactions on Military Electronics, 1962
- The Detection of Radar Echoes in Noise. IIJournal of the Society for Industrial and Applied Mathematics, 1960
- The Detection of Radar Echoes in Noise. IJournal of the Society for Industrial and Applied Mathematics, 1960