Kinetics of Nucleoside Triphosphate Cleavage and Phosphate Release Steps by Associated Rabbit Skeletal Actomyosin, Measured Using a Novel Fluorescent Probe for Phosphate
- 1 September 1997
- journal article
- research article
- Published by American Chemical Society (ACS) in Biochemistry
- Vol. 36 (39) , 11828-11836
- https://doi.org/10.1021/bi970540h
Abstract
We have measured the kinetics of inorganic phosphate (Pi) release during a single turnover of actomyosin nucleoside triphosphate (NTP) hydrolysis using a double-mixing stopped-flow spectrofluorometer, at very low ionic strength to increase the affinity of myosin−ATP and myosin−ADP−Pi to actin. Myosin subfragment 1 and a series of nucleoside triphosphates were mixed and incubated for ∼1−10 s to allow NTP to bind to myosin and generate a steady state mixture of myosin−NTP and myosin−NDP−Pi. The steady state intermediates were then mixed with actin. The kinetics of Pi release were measured using a fluorescent probe for Pi, based on a phosphate binding protein [Brune et al. (1994) Biochemistry 33, 8262−8271]. These data are correlated with quenched-flow data, where the extent of the rapid burst of hydrolysis during the first turnover of ATP hydrolysis was followed by chemical quenching of the reaction mix at various times after rapidly mixing ATP and myosin subfragment 1. From the double-mixing actomyosin measurements, the kinetics of Pi release are biphasic. The fast phase corresponds to Pi release from the associated actomyosin−ADP−Pi complex. The slow phase measures the rate of the cleavage step on associated actomyosin. At saturating actin, there is a correlation between the amplitude of the fast phase and the size of the Pi burst observed by quenched flow in the absence of actin: the size of this phase corresponds to the amount of myosin−ADP−Pi formed during the first mix. For ATP at 20 °C the rate of the Pi release step is 75 (±5) s-1, 25-fold larger than the cleavage step, which is the rate-limiting step of actomyosin ATP hydrolysis at saturating actin. The rate constant of Pi release varies only slightly with nucleoside structure. The rate constant of the slow phase of the Pi release (measuring cleavage) is highly dependent upon the structure of the NTP substrate.Keywords
This publication has 13 references indexed in Scilit:
- Time resolved measurements show that phosphate release is the rate limiting step on myofibrillar ATPasesFEBS Letters, 1995
- A model of the release of myosin heads from actin in rapidly contracting muscle fibersBiophysical Journal, 1994
- Myofibrillar ATPase activity and mechanical performance of skinned fibres from rabbit psoas muscle.The Journal of Physiology, 1994
- Dissociation of force from myofibrillar MgATPase and stiffness at short sarcomere lengths in rat and toad skeletal muscle.The Journal of Physiology, 1989
- Phosphate burst in permeable muscle fibers of the rabbitBiophysical Journal, 1986
- Dependence of adenosine triphosphatase activity of rabbit psoas muscle fibres and myofibrils on substrate concentration.The Journal of Physiology, 1985
- The kinetics of magnesium adenosine triphosphate cleavage in skinned muscle fibres of the rabbit.The Journal of Physiology, 1984
- New ribose-modified fluorescent analogs of adenine and guanine nucleotides available as subtrates for various enzymesBiochimica et Biophysica Acta (BBA) - Protein Structure and Molecular Enzymology, 1983
- Separation of subfragment-1 isoenzymes from rabbit skeletal muscle myosinNature, 1975
- The reversibility of adenosine triphosphate cleavage by myosinBiochemical Journal, 1973