Review: Fabrication of engineering ceramics by injection moulding. II. Techniques
- 1 January 1986
- journal article
- Published by Elsevier in International Journal of High Technology Ceramics
- Vol. 2 (4) , 249-278
- https://doi.org/10.1016/0267-3762(86)90020-2
Abstract
No abstract availableKeywords
This publication has 23 references indexed in Scilit:
- Review: Fabrication of engineering ceramics by injection moulding. I. Materials selectionInternational Journal of High Technology Ceramics, 1986
- High‐Yield Synthesis of Si3N4/SiC Ceramic Materials by Pyrolysis of a Novel PolyorganosilazaneJournal of the American Ceramic Society, 1984
- Formation, Packing, and Sintering of Monodisperse TiO2 PowdersJournal of the American Ceramic Society, 1982
- Influence of high injection pressures on the internal stress level in injection moulded specimensPolymer, 1975
- Analysis of the nonvolatile oxidation products of polypropylene I. Thermal oxidationJournal of Polymer Science Part A-1: Polymer Chemistry, 1970
- Thermal decomposition products of polypropyleneJournal of Polymer Science Part A-1: Polymer Chemistry, 1969
- Prediction of the Viscosity of Multimodal Suspensions from Unimodal Viscosity DataTransactions of the Society of Rheology, 1968
- Thermal decomposition products of polyethyleneJournal of Polymer Science Part A-1: Polymer Chemistry, 1968
- The metal salts catalysed autoxidation of atactic polypropylene in solution II—Behaviour of Co, Ni, Fe and Cu salts as catalystsPolymer, 1968
- Infrared study of oxygenated groups formed in polyethylene during oxidationJournal of Polymer Science, 1960