High-Volume Diffusion Denuder Sampler for the Routine Monitoring of Fine Particulate Matter: I. Design and Optimization of the PC-BOSS
Open Access
- 1 April 2002
- journal article
- research article
- Published by Taylor & Francis in Aerosol Science and Technology
- Vol. 36 (4) , 369-382
- https://doi.org/10.1080/027868202753571205
Abstract
Fine particulate mass will frequently be significantly underestimated in urban environments using current EPA federal reference method (FRM) single filter samplers because of loss of semivolatile organic material and nitrate from the particles during sampling. Previously described diffusion denuder samplers, such as the Brigham Young University organic sampling system (BOSS) and BIG BOSS, eliminate both positive and negative sampling artifacts by removing the gas-phase material before fine particulate mass is collected on a quartz filter and a sequential sorbent filter or bed. However, these samplers are not amenable to routine field use because they require multiple systems to accurately account for the efficiency of the denuder for each sample. The denuder efficiency is substantially improved by combining a conventional 2.5 w m cutpoint inlet and a low cutpoint virtual impactor particle concentrator to provide concentrated fine particles (0.1-2.5 w m) to a BOSS diffusion denuder sampling system (PC-BOSS). The performance of both the particle concentrator and the diffusion denuder in the PC-BOSS has been evaluated. Under optimized conditions, the minor to total flow ratio for the concentrator is 25% and the concentrator efficiency is 70-90% for sulfate and 60-85% for soot, depending on the particle size distribution of these species. The particle loss in the concentrator is about 6%. The particle loss in the denuder system is negligible. At the recommended optimum minor flow (concentrated particles, 25% of the total flow), most of the gas-phase material is discarded by the particle concentrator before the concentrated fine particles enter the diffusion denuder. At an optimized inlet flow of 150 L/min with a flow through the denuder of 38 L/min, the overall efficiency of the PC-BOSS for the removal of gas-phase organic material, SO 2 , and HNO 3 is over 99%. Therefore independent determination of the denuder breakthrough can be eliminated in the PC-BOSS.Keywords
This publication has 21 references indexed in Scilit:
- A technique to expose animals to concentrated fine ambient aerosols.Environmental Health Perspectives, 1995
- Sources of Urban Contemporary Carbon AerosolEnvironmental Science & Technology, 1994
- High-Volume Air Sampler for Particle and Gas Sampling.2.Use of Backup Filters To Correct for the Adsorption of Gas-Phase Polycyclic Aromatic Hydrocarbons to the Front FilterEnvironmental Science & Technology, 1994
- A multiple-system, multi-channel diffusion denuder sampler for the determination of fine-particulate organic material in the atmosphereAtmospheric Environment. Part A. General Topics, 1993
- Comparison of annular denuder and filter pack collection of HNO3 (g), HNO2((g), SO2 (g), and particulate-phase nitrate, nitrite and sulfate in the south-west desertAtmospheric Environment. Part A. General Topics, 1991
- Vapor adsorption artifact in the sampling of organic aerosol: Face velocity effectsAtmospheric Environment. Part A. General Topics, 1990
- Evaluation of an annular denuder/filter pack system to collect acidic aerosols and gasesEnvironmental Science & Technology, 1988
- Development of High Efficiency Virtual ImpactorsAerosol Science and Technology, 1988
- The relative importance of atmospheric sulfates and nitrates in visibility reductionAtmospheric Environment (1967), 1981
- Virtual impactors: a theoretical study.Environmental Science & Technology, 1980