Liquid compositions from low‐pressure experimental melting of pelitic rock from Morton Pass, Wyoming, USA
- 28 January 2004
- journal article
- Published by Wiley in Journal of Metamorphic Geology
- Vol. 22 (2) , 65-78
- https://doi.org/10.1111/j.1525-1314.2004.00497.x
Abstract
Low‐pressure crystal‐liquid equilibria in pelitic compositions are important in the formation of low‐pressure, high‐temperature migmatites and in the crystallization of peraluminous leucogranites and S‐type granites and their volcanic equivalents. This paper provides data from vapour‐present melting of cordierite‐bearing pelitic assemblages and augments published data from vapour‐present and vapour‐absent melting of peraluminous compositions, much of which is at higher pressures. Starting material for the experiments was a pelitic rock from Morton Pass, Wyoming, with the major assemblage quartz‐K feldspar‐biotite‐cordierite, approximately in the system KFMASH. A greater range in starting materials was obtained by addition of quartz and sillimanite to aliquots of this rock. Sixty‐one experiments were carried out in cold‐seal apparatus at pressures of 1–3.5 kbar (particularly 2 kbar) and temperatures from 700 to 840 °C, with and without the addition of water. In the vapour‐present liquidus relations at 2 kbar near the beginning of melting, the sequence of reactions with increasing temperature is: Qtz + Kfs + Crd + Sil + Spl + V = L; Qtz + Kfs + Crd + Spl + Ilm + V = Bt + L; and Qtz + Bt + V = Crd + Opx + Ilm + L. Vapour‐absent melting starts at about 800 °C with a reaction of the form Qtz + Bt = Kfs + Crd + Opx + Ilm + L. Between approximately 1–3 kbar the congruent melting reaction is biotite‐absent, and biotite is produced by incongruent melting, in contrast to higher‐pressure equilibria. Low pressure melts from pelitic compositions are dominated by Qtz‐Kfs‐Crd. Glasses at 820–840 °C have calculated modes of approximately Qtz42Kfs46Crd12. Granites or granitic leucosomes with more than 10–15% cordierite should be suspected of containing residual cordierite. The low‐pressure glasses are quite similar to the higher‐pressure glasses from the literature. However, XMg increases from about 0.1–0.3 with increasing pressure from 1 to 10 kbar, and the low‐temperature low‐pressure glasses are the most Fe‐rich of all the experimental glasses from pelitic compositions.Keywords
This publication has 29 references indexed in Scilit:
- Cordierite as a sensor of fluid conditions in high‐grade metamorphism and crustal anatexisJournal of Metamorphic Geology, 2002
- Partial melting in the Inzie Head gneisses: the role of water and a petrogenetic grid in KFMASH applicable to anatectic pelitic migmatitesJournal of Metamorphic Geology, 2001
- Fluids, P–T paths and the fates of anatectic melts in the Earth's crustPublished by Elsevier ,1998
- Experimental Constraints on Himalayan AnatexisJournal of Petrology, 1998
- Effects of P, f(O2) and Mg/Fe Ratio on Dehydration Melting of Model MetagreywackesJournal of Petrology, 1996
- Evidence of Two Different Components in a Hercynian Peraluminous Cordierite-bearing Granite: the San Basilio Intrusion (Central Sardinia, Italy)Journal of Petrology, 1996
- In‐situ migmatite and hybrid diatexite at Mt Stafford, central AustraliaJournal of Metamorphic Geology, 1996
- Cordierite in felsic igneous rocks: a synthesisMineralogical Magazine, 1995
- Decompression and anatexis of Himalayan metapelitesTectonics, 1994
- The Arburese igneous complex (SW Sardinia, Italy) — an example of dominant igneous fractionation leading to peraluminous cordierite-bearing leucogranites as residual meltsChemical Geology, 1991