A New Measuring Machine for the Rate of Fuel Injection
- 1 January 1953
- journal article
- Published by Japan Society of Mechanical Engineers in Transactions of the Japan Society of Mechanical Engineers
- Vol. 19 (84) , 29-32
- https://doi.org/10.1299/kikai1938.19.84_29
Abstract
In order to shorten the time for measuring, the new measuring machine for the rate of injection was investigated and manufactured under the following construction instead of the old machine which has single slit. We installed many slits each of which had one oil receiver under it and these positions were situated 1 degree for each 4 degrees on the outer edge of the round plate, which rotates horizontally. At the same time we also obtained a shape of slit for the minimum error of measurement as the angle type. Then the rate of injections meaured by this machine proved that the early aims we was fulfilled, namely it anabled us to shorten the time for measuring, and also to make the erros of measurements small enough.Keywords
This publication has 0 references indexed in Scilit: