Calcium phosphate formation at the surface of bioactive glass in vitro
- 1 August 1991
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 25 (8) , 1019-1030
- https://doi.org/10.1002/jbm.820250808
Abstract
The calcium phosphate formation at the surface of bioactive glass was studied in vitro. Glass rods and grains were immersed in different aqueous solutions and studied by means of scanning electron microscopy and energy dispersive x‐ray analysis. Surface morphological changes and weight loss of corroded grains were monitored. In‐depth compositional profiles were determined for rods immersed in the different solutions. The solutions used were tris‐buffer (trishydroxy‐methylaminomethane + HCl), tris‐buffer prepared using citric acid (trishydroxy‐methylaminomethane + C6H8O7·H2O), and a simulated body fluid, SBF, containing inorganic ions close in concentration to those in human blood plasma. It was found that the calcium phosphate formation at the surface of bioactive glass in vitro proceeds in two stages. When immersing the glass in tris or in SBF a Ca,P‐rich surface layer forms. This accumulation takes place within the silica structure. Later, apatite crystals forming spherulites appear on the surface. The Ca/P‐ratio of initially formed calcium phosphate was found to be about unity. It is proposed that this is due to bonding of phosphate to a silica gel. The surface is stabilized, i.e., leaching is retarded, by the rapid Ca,P‐accumulation within the silica structure before apatite crystals are observed on the surface. It is proposed that the initially formed calcium phosphate is amorphous and that the crystallization is initiated within the silica gel. The crystallizing surface provides nucleation sites for extensive apatite formation on the glass surface. In the presence of citrate no Ca,P‐accumulation occur at the glass surface, but soluble Ca‐citrate complexes form. By comparing the weight loss during corrosion in tris with that in the calcium and phosphate containing SBF, it is possible to establish whether the glass can induce apatite formation at its surface or not.Keywords
This publication has 13 references indexed in Scilit:
- Calcium phosphate formation at the surface of bioactive glass in vivoJournal of Non-Crystalline Solids, 1990
- Surface chemistry of bioactive glass-ceramicsJournal of Non-Crystalline Solids, 1990
- Bioactive CeramicsAnnals of the New York Academy of Sciences, 1988
- Compositional dependence of formation of an apatite layer on glass-ceramics in simulated physiological solutionJournal of Materials Science, 1987
- The mechanism of ?primary mineralization? in the reaction of bone to injury and administration of implantJournal of Biomedical Materials Research, 1985
- Surface-Active BiomaterialsScience, 1984
- Auger Spectroscopic Analysis of Bioglass Corrosion FilmsJournal of the American Ceramic Society, 1976
- Multilayer Corrosion Films on Bioglass SurfacesJournal of the American Ceramic Society, 1974
- Direct chemical bond of bioactive glass‐ceramic materials to bone and muscleJournal of Biomedical Materials Research, 1973
- Bonding mechanisms at the interface of ceramic prosthetic materialsJournal of Biomedical Materials Research, 1971