Failure of demand pacing with small surface area electrodes.
- 1 July 1976
- journal article
- research article
- Published by Wolters Kluwer Health in Circulation
- Vol. 54 (1) , 128-132
- https://doi.org/10.1161/01.cir.54.1.128
Abstract
As pacemaker electrode myocardial contact area is reduced, the energy required to stimulate the heart decreases; but the effect of surface area on an electrode''s ability to transmit R-wave potentials was not well documented. Endocardial and intramyocardial R-wave potentials were measured in 10 dogs with 7 commercially available pacemaker electrodes of different surface area. With a load impedance of 1000 ohms, there was a direct correlation between surface area and the R-wave potentials measured. The amplitude of the R-wave that resulted from conduction from the heart to the sensor via the electrode system decreased with decreasing surface area. A similar direct correlation was seen between the R-wave potentials measured and the threshold current and energy requirements. With the present trend toward utilization of small surface area electrodes to reduce pacemaker cell drain, care must be taken to optimize pacemaker circuit impedance if sensing problems are to be avoided.This publication has 4 references indexed in Scilit:
- The non-hermetically sealed pacemaker myth, or, Navy-Ribicoff 22,000—FDA-Weinberger 0The Journal of Thoracic and Cardiovascular Surgery, 1976