Shear and extensional flow of reinforced plastics in injection molding. I. Effects of temperature and shear rate with bulk molding compound
- 1 October 1985
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 25 (15) , 968-979
- https://doi.org/10.1002/pen.760251510
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Rheology of unsaturated polyester resins. III. Effects of filler and low‐profile additive on the thickening behavior of unsaturated polyester resinJournal of Applied Polymer Science, 1983
- Rheology of unsaturated polyester resins. II. Thickening behavior of unsaturated polyester and vinyl ester resinsJournal of Applied Polymer Science, 1983
- Rheology of unsaturated polyester resins. I. Effects of filler and low-profile additive on the rheological behavior of unsaturated polyester resinJournal of Applied Polymer Science, 1983
- The rheology and mold flow of polyester sheet molding compoundPolymer Composites, 1981
- Rheology of short glass fiber‐reinforced thermoplastics and its application to injection molding. III. Use of a high shear rate capillary rheometer in the injection molding shear rate rangePolymer Engineering & Science, 1981
- Rheology of short glass fiber‐reinforced thermoplastics and its application to injection molding. II. The effect of material parametersPolymer Engineering & Science, 1980
- Rheology of short glass fiber‐reinforced thermoplastics and its application to injection molding I. Fiber motion and viscosity measurementPolymer Engineering & Science, 1980
- Principles of Polymer ProcessingPublished by Springer Nature ,1979
- Influence of glass fibers on the extrusion and injection molding characteristics of polyethylene and polystyrene meltsPolymer Engineering & Science, 1978
- End Corrections in the Capillary Flow of PolyethyleneJournal of Applied Physics, 1957