We show results from the first set of measurements conducted to validate extinction data from the satellite sensor SAM II. Dustsonde-measured number density profiles and lidar-measured backscattering profiles for two days are converted to extinction profiles using the optical modeling techniques described in the companion Paper I (Russell et al., 1981). At heights ∼2 km and more above the tropopause, the dustsonde data are used to restrict the range of model size distributions, thus reducing uncertainties in the conversion process. At all heights, measurement uncertainties for each sensor are evaluated, and these are combined with conversion uncertainties to yield the total uncertainty in derived data profiles. The SAM II measured, dustsonde-inferred, and lidar-inferred extinction profiles for both days are shown to agree within their respective uncertainties at all heights above the tropopause. Near the tropopause, this agreement depends on the use of model size distributions with more relatively large particles (radius ≳0.6 μm) than are present in distributions used to model the main stratospheric aerosol peak. The presence of these relatively large particles is supported by measurements made elsewhere and is suggested by in situ size distribution measurements reported here. These relatively large particles near the tropopause are likely to have an important bearing on the radiative impact of the total stratospheric aerosol. The agreement in this experiment supports the validity of the SAM II extinction data and the SAM II uncertainty estimates derived from an independent error analysis. Recommendations are given for reducing the uncertainties of future correlative experiments.