STUDY ON THE CORRELATION OF WORKPIECE MECHANICAL PROPERTIES FROM COMPRESSION AND CUTTING TESTS
- 1 August 1997
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 1 (1) , 67-79
- https://doi.org/10.1080/10940349708945638
Abstract
Metal cutting tests were conducted on annealed and cold-worked 1100-grade aluminum and 33000-grade leaded brass at a sufficiently slow speed (254 mm/min) that thermal influences on workpiece material properties could be neglected. The mechanical properties of the materials were evaluated in compression using conventional low strain rate test procedures. The material behavior during metal cutting and compression was consistent when the work hardening and strain rate hardening response of these materials was considered. The values of strain rate sensitivity coefficient are in reasonable agreement with literature values. These results support previous data indicating that the material response during metal cutting is consistent with the mechanical behavior determined using conventional material test procedures.Keywords
This publication has 3 references indexed in Scilit:
- The Mechanical Behavior of Zinc During MachiningJournal of Engineering Materials and Technology, 1995
- Compression testing techniques to determine the stress/strain behavior of metals subject to finite deformationMetallurgical Transactions A, 1992
- Basic Mechanics of the Metal-Cutting ProcessJournal of Applied Mechanics, 1944