Microactuation based on thermally-driven phase-change
- 9 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1037-1040
- https://doi.org/10.1109/sensor.1991.149073
Abstract
The authors describe a microactuator based on thermally induced liquid-vapor phase-change in a partially filled closed cavity. A test structure for studying such systems has been designed and fabricated. The cavity is 900 mu m*900 mu m*300 mu m in size with a 600 mu m*800 mu m heater covering the floor of the cavity and elevated approximately 10 mu m above it. These heaters have open diamond-shaped unit cells defined by 12 mu m-wide 3 mu m-thick bulk silicon beams and provide an overall electrical resistance of 3-10 Omega . The thermal resistance is typically 4-6 degrees C/mW so that the heater temperature rises approximately 22 degrees C for input current levels of 25 mA. Using Freon-11 as the cavity fluid with partial filling, very modest drive levels are thus able to sustain a 1-atm pressure rise within the cavity. Overdriving the heaters at 100 mW results in a simulated pressure rise of 1 atm in 40 ms, showing that operation can be rapid as well.<>Keywords
This publication has 18 references indexed in Scilit:
- Mathematical model and experimental verification of shape memory alloy for designing micro actuatorPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A numerical method for phase-change problemsInternational Journal of Heat and Mass Transfer, 1990
- A 1024-element high-performance silicon tactile imagerIEEE Transactions on Electron Devices, 1990
- A multi-element monolithic mass flowmeter with on-chip CMOS readout electronicsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1990
- A design overview of an eccentric-motion electrostatic microactuator (the wobble motor)Sensors and Actuators, 1989
- Analysis of noise margin and speed of GaAs MESFET DCFL using UM-SPICEIEEE Transactions on Electron Devices, 1986
- The Evolution of Enhanced Surface Geometries for Nucleate BoilingHeat Transfer Engineering, 1981
- Dynamic Model of Enhanced Boiling Heat Transfer on Porous Surfaces—Part I: Experimental InvestigationJournal of Heat Transfer, 1980
- The Effect of the London-Van Der Waals Dispersion Force on Interline Heat TransferJournal of Heat Transfer, 1978
- Boiling Characteristics and Burnout Phenomena on Heating Surface Covered with Woven ScreensJournal of Nuclear Science and Technology, 1975