Protein adsorption to poly(ethylene oxide) surfaces
- 1 December 1991
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 25 (12) , 1547-1562
- https://doi.org/10.1002/jbm.820251211
Abstract
Surfaces containing poly(ethylene oxide) (PEO) are interesting biomaterials because they exhibit low degrees of protein adsorption and cell adhesion. In this study different molecular weight PEO molecules were covalently attached to poly(ethylene terephthalate) (PET) films using cyanuric chloride chemistry. Prior to the PEO immobilization, amino groups were introduced onto the PET films by exposing them to an allylamine plasma glow discharge. The amino groups on the PET film were next activated with cyanuric chloride and then reacted with bis- amino PEO. The samples were characterized by scanning electron microscopy, water contact angle measurements, gravimetric analysis, and electron spectroscopy for chemical analysis (ESCA). The adsorption of 125I-labeled baboon fibrinogen and bovine serum albumin was studied from buffer solutions. Gravimetric analysis indicated that the films grafted with the low-molecularweight PEO contained many more PEO molecules than the surfaces grafted with higher-molecular-weight PEO. The highmolecular-weight PEO surfaces, however, exhibited greater wettability (lower water contact angles) and less protein adsorption than the low-molecular-weight PEO surfaces. Adsorption of albumin and fibrinogen to the PEO surfaces decreased with increasing PEO molecular weight up to 3500. A further increase in molecular weight resulted in only slight decreases in protein adsorption. Protein adsorption studies as a function of buffer ionic strength suggest that there may be an ionic interaction between the protein and the allylamine surface. The trends in protein adsorption together with the water contact angle results and the gravimetric analysis suggest that a kind of “cooperative” water structuring around the larger PEO molecules may create an “excluded volume” of the hydrated polymer coils. This may be an important factor contributing to the observed low protein adsorption behavior.Keywords
This publication has 35 references indexed in Scilit:
- Blood compatibility of PEO grafted polyurethane and HEMA/styrene block copolymer surfacesJournal of Biomedical Materials Research, 1990
- Surface properties of copolymers of alkyl methacrylates with, methoxy (polyethylene oxide) metiiacrylates and their application as protein-resistant coatingsBiomaterials, 1990
- Immobilization of poly(ethylene oxide) on poly(ethylene terephthalate) using a plasma polymerization processJournal of Applied Polymer Science, 1989
- Nonthrombogenic Bioactive SurfacesaAnnals of the New York Academy of Sciences, 1987
- Surface grafting of polyethyleneoxide optimized by means of ESCAColloid and Polymer Science, 1987
- Surface properties and blood compatibility of polyurethaneureasBiomaterials, 1986
- Synthesis and Characterization of Non-Fouling Polymer Surfaces: I. Radiation Grafting of Hydroxyethyl Methacrylate and Polyethylene Glycol Methacrylate onto Silastic FilmJournal of Bioactive and Compatible Polymers, 1986
- Interaction of poly(ethylene oxide) with solvents: 1. Preparation and swelling of a crosslinked poly(ethylene oxide) hydrogelPolymer, 1982
- Phase separation of non-ionic surfactant solutions. A treatment of the micellar interaction and formJournal of the Chemical Society, Faraday Transactions 2: Molecular and Chemical Physics, 1982
- Adsorption of proteins from plasma to a series of hydrophilic-hydrophobic copolymers. I. Analysis with thein situ radioiodination techniqueJournal of Biomedical Materials Research, 1981