Dense polymer film and membrane formation via the dry-cast process part II. Model validation and morphological studies
- 1 September 1994
- journal article
- Published by Elsevier in Journal of Membrane Science
- Vol. 94 (1) , 281-298
- https://doi.org/10.1016/0376-7388(93)e0229-d
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- Dense polymer film and membrane formation via the dry-cast process part I. Model developmentJournal of Membrane Science, 1994
- Structures and gas separation properties of asymmetric polysulfone membranes made by dry, wet, and dry/wet phase inversionJournal of Applied Polymer Science, 1991
- Production and characterization of homogeneous porous polymer filmsJournal of Membrane Science, 1988
- Asymmetric membrane formation. Is the evaporation step necessary?Desalination, 1987
- Gravimetric analysis of membrane casting I. Cellulose acetate — acetone binary casting solutionsJournal of Membrane Science, 1982
- The effect of short air exposure periods on the performance of cellulose acetate membranes from casting solutions with high cellulose acetate contentJournal of Applied Polymer Science, 1978
- Preparation of the skinned membranes without evaporation stepJournal of Polymer Science Part C: Polymer Letters, 1973
- Concerning the microstructure of dry‐RO membranesJournal of Applied Polymer Science, 1973
- The structure of cellulose acetate membranes II. The physical and transport characteristics of the porous layer of anisotropic membranesDesalination, 1972
- Evaporation rate and equilibrium phase separation data in relation to casting conditions and performance of porous cellulose acetate reverse osmosis membranesJournal of Applied Polymer Science, 1970