Measurement of quasi-mean resultant force using the vibrational signal of spindle in milling
- 31 December 1991
- journal article
- Published by Elsevier in International Journal of Machine Tools and Manufacture
- Vol. 31 (3) , 295-304
- https://doi.org/10.1016/0890-6955(91)90076-f
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- The effect of runout on cutting geometry and forces in end millingPublished by Elsevier ,2003
- In-Process Detection of Tool Failure in Milling Using Cutting Force ModelsJournal of Engineering for Industry, 1989
- A Note on the Significance of the Quasi-Mean Resultant Force and the Modelling of Instantaneous Torque and Forces in Peripheral Milling OperationsJournal of Engineering for Industry, 1988
- The Detection of Tool Breakage in Milling OperationsJournal of Engineering for Industry, 1988
- The identification of radial width and axial depth of cut in peripheral millingInternational Journal of Machine Tools and Manufacture, 1987
- Observations on the mean values of forces, torque and specific power in the peripheral milling processInternational Journal of Machine Tool Design and Research, 1985
- A Mechanistic Model for the Prediction of the Force System in Face Milling OperationsJournal of Engineering for Industry, 1984
- Modelling of Cutting Force Pulsation in Face-MillingCIRP Annals, 1983
- Special Aspects of Chatter in MillingJournal of Vibration and Acoustics, 1983
- An investigation into the cutting force pulsations during milling operationsInternational Journal of Machine Tool Design and Research, 1961