In Situ Measurement of Young’s Modulus and Residual Stress of Thin Electroless Nickel Films for Mems Applications
- 1 January 1994
- journal article
- Published by Springer Nature in MRS Proceedings
Abstract
This paper reports in situ measurement of Young’s modulus and residual stress of electroless nickel films through the use of microfabricated nickel test structures, including electrostatic microactuators and passive devices. The test structures are fabricated in a new surface micromachining process, termed “nickel surface micromachining”, using electroless plated nickel as the structural layer and polysilicon as the sacrificial layer. Subsequent to fabrication, lateral resonant-type electrostatic microactuators of different geometries are resonated by electrical excitation. Using the measured resonant frequencies and knowledge of the device geometry, the Young’s modulus of the film is determined. The passive electroless nickel microstructures deform upon completion of the fabrication process due to residual stress in the film. Measurement of this deformation in conjunction with an appropriate mechanical model is used to determine the residual stress in the films.Keywords
This publication has 4 references indexed in Scilit:
- Novel microstructures for the i n s i t u measurement of mechanical properties of thin filmsJournal of Applied Physics, 1987
- Microfabricated structures for the i n s i t u measurement of residual stress, Young’s modulus, and ultimate strain of thin filmsApplied Physics Letters, 1987
- A simple technique for the determination of mechanical strain in thin films with applications to polysiliconJournal of Applied Physics, 1985
- Determination of Stress in Films on Single Crystalline Silicon SubstratesReview of Scientific Instruments, 1965