Modification of gel‐drawn poly(vinyl alcohol) fibers with formaldehyde
- 5 February 1990
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 39 (3) , 695-705
- https://doi.org/10.1002/app.1990.070390318
Abstract
Poly(vinyl alcohol) fibers which were drawn from dried gels were chemically treated with formaldehyde to induce crosslinking in the amorphous phase. The room temperature storage modulus decreased early in the treatment, to an almost constant value of 50–60% of the initial modulus of the fiber. This behavior was independent of the concentration of formaldehyde used. The modulus at low temperature was also reduced, and no Tg peak could be seen in heavily treated fibers. The modulus above the original Tg, 70°C, was much less affected. The crystallinity determined by DSC fell by one third as the room temperature modulus decreased, and X‐ray diffraction indicated a reduction in the crystal length along the chain direction at the same time. Thus, under the conditions of treatment used, the loss of properties due to destruction of crystals outweighs the stiffening and reduced water sensitivity of the crosslinked amorphous phase.Keywords
This publication has 7 references indexed in Scilit:
- Thermally reactive oligomers of aromatic poly(ether sulphone) containing poly(dimethylsiloxane): 1. Synthesis and characterizationPolymer, 1987
- High modulus poly (vinyl alcohol) fibers by zone drawingJournal of Materials Research, 1986
- Gel-drawn fibres of poly(vinyl alcohol)Journal of Materials Science, 1985
- On shrinkage and molecular extensionJournal of Materials Science Letters, 1984
- A structural model for high‐modulus polyethylene derived from entanglement conceptsJournal of Polymer Science: Polymer Physics Edition, 1983
- Mechanical properties and fine structure of drawn polymersJournal of Polymer Science Part C: Polymer Symposia, 1967
- Dimensional Changes in Systems of Fibrous Macromolecules: Polyethylene1Journal of the American Chemical Society, 1959