Reduction of Ohmic Contact Resistance on n-Type 6H-SiC by Heavy Doping
- 1 January 1995
- journal article
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 34 (1A) , L7
- https://doi.org/10.1143/jjap.34.l7
Abstract
Ohmic contacts with low contact resistances were fabricated on n+ 6H-SiC layers grown by liquid phase epitaxy. Ni was deposited on the layers for the contact metal Ohmic characteristics were obtained on as-deposited n+ samples with carrier concentrations higher than about 5×1019 cm-3. The contact resistance was lowered by thermal annealing at 1000° C for 5 minutes. A specific contact resistance as low as 1×10-6 Ω· cm2 was fabricated on an n+ layer with a carrier concentration of 4.5×1020 cm-3. It was found that Ti/Al, which is widely used as a p-type ohmic contact metal, also made a good ohmic contact on the n+ layer.Keywords
This publication has 6 references indexed in Scilit:
- Contact resistance measurements on p-type 6H-SiCApplied Physics Letters, 1993
- Investigation of thin-film Ni/single-crystal SiC interface reactionJournal of Applied Physics, 1987
- Solid state reaction of titanium and (0001) α-SiCThin Solid Films, 1980
- Fabrication of 6H-SiC light-emitting diodes by a rotation dipping technique: Electroluminescence mechanismsJournal of Applied Physics, 1979
- Silicon carbide blue-emitting diodes produced by liquid-phase epitaxySolid-State Electronics, 1978
- Specific contact resistance of metal-semiconductor barriersSolid-State Electronics, 1971