Heat transfer enhancement in a ribbed duct using vortex generators
- 30 September 1993
- journal article
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 36 (14) , 3497-3508
- https://doi.org/10.1016/0017-9310(93)90167-5
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Turbulent Heat Transfer Augmentation and Friction in Periodic Fully Developed Channel FlowsJournal of Heat Transfer, 1992
- Vortex Generator Induced Heat Transfer Augmentation Past a Rib in a Heated Duct Air FlowJournal of Heat Transfer, 1992
- An effective installation of turbulence promoters for heat transfer augmentation in a vertical rib-heated channelInternational Journal of Heat and Mass Transfer, 1992
- Enhancement of single phase convective heat transfer from protruding elements using vortex generatorsInternational Journal of Heat and Mass Transfer, 1991
- Measurements of turbulent heat transport in a boundary layer with an embedded streamwise vortexInternational Journal of Heat and Mass Transfer, 1991
- Experimental and Computational Study of Turbulent Flows in a Channel With Two Pairs of Turbulence Promoters in TandemJournal of Fluids Engineering, 1990
- Minimum-dissipation transport enhancement by flow destabilization: Reynolds’ analogy revisitedJournal of Fluid Mechanics, 1988
- Experimental and Computational Investigation of the Two-Dimensional Channel Flow Over Two Fences in TandemJournal of Fluids Engineering, 1988
- Forced convection mass transfer: Part III. Increased mass transfer from a flat plate caused by the wake from cylinders located near the edge of the boundary layerAIChE Journal, 1966
- Forced convection mass transfer: Part II. Effect of wires located near the edge of the laminar boundary layer on the rate of forced convection from a flat plateAIChE Journal, 1965