Lubrication by Grinding Fluids at Normal and High Wheel Speeds
- 1 January 1972
- journal article
- research article
- Published by Taylor & Francis in A S L E Transactions
- Vol. 15 (4) , 261-268
- https://doi.org/10.1080/05698197208981426
Abstract
An investigation is described of the lubricating effects of various grinding fluids at both normal and high wheel speeds under geometrically similar conditions. Grinding fluids include air (dry), water, soluble oil in two concentrations, and cutting oil. Results indicate that the specific cutting energy and the attritious wear of the abrasive grains are reduced by lubrication, but the rubbing friction between the workpiece and the wear flats on the grains is not. With high wheel speed, the specific cutting energy is lower with all grinding fluids than with normal wheel speed, but the attritious wear rate is greater. These lubricating effects are related to results for G-ratio, surface finish, and burning conditions.Keywords
This publication has 6 references indexed in Scilit:
- The Wear of Grinding Wheels: Part 2—Fracture WearJournal of Engineering for Industry, 1971
- The Wear of Grinding Wheels: Part 1—Attritious WearJournal of Engineering for Industry, 1971
- Temperature in Semi-Infinite and Cylindrical Bodies Subjected to Moving Heat Sources and Surface CoolingJournal of Heat Transfer, 1970
- Shear Stress in Metal CuttingJournal of Engineering for Industry, 1970
- The Effect of Oxygen and Water on the Dynamics of Chip Formation during GrindingA S L E Transactions, 1969
- Mechanics of cutting and rubbing in simulated abrasive processesWear, 1963