EMI associated with inter-board connection for module-on-backplane and stacked-card configurations
- 20 January 2003
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 797-802 vol.2
- https://doi.org/10.1109/isemc.1999.810121
Abstract
EMI associated with inter-board connection was studied through common-mode current measurements and FDTD modeling for stacked-card and module-on-backplane configurations. Three types of connections were investigated experimentally including an open pin field connection, an "ideal" semi-rigid coaxial cable connection, and a production connector. Both microstrip and stripline signal routing on the PCB were investigated. The results indicated signal routing on the PCBs or the inter-board connection can dominate the EMI process. Several cases of connector geometries were studied using FDTD modeling and good agreement was achieved between the measured and FDTD results.Keywords
This publication has 10 references indexed in Scilit:
- Experimental and numerical investigations of fundamental radiation mechanisms in PCB designs with attached cablesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Transfer impedance testing of multi-conductor shielded connectors of arbitrary cross-sectionPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- An improved triaxial cell for transfer impedance measurements on multipins backplane connectorsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- FDTD and experimental investigation of EMI from stacked-card PCB configurationsIEEE Transactions on Electromagnetic Compatibility, 2001
- Net and partial inductance of a microstrip ground planeIEEE Transactions on Electromagnetic Compatibility, 1998
- Investigation of fundamental EMI source mechanisms driving common-mode radiation from printed circuit boards with attached cablesIEEE Transactions on Electromagnetic Compatibility, 1996
- FD-TD analysis of electromagnetic radiation from modules-on-backplane configurationsIEEE Transactions on Electromagnetic Compatibility, 1995
- A perfectly matched layer for the absorption of electromagnetic wavesJournal of Computational Physics, 1994
- Backplane Connector Radiated Emission And Shielding EffectivenessPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1992
- Measured electromagnetic shielding performance of commonly used cables and connectorsIEEE Transactions on Electromagnetic Compatibility, 1988