Low Sulfur-Sulfenamide Accelerator Combinations for Injection Molding of Cis-1,4-Poly(Isoprene)

Publisher Website
Google Scholar
Abstract
Earlier work with cis-l,4-poly(isoprene) suggested that low levels of sulfur and high levels of sulfenamide accelerator with high levels of secondary accelerator was an excellent method for curing injection molded stocks. However, subsequent experience showed that despite the benefits of reduced sulfur concentrations on reversion, increased sulfur, increased sulfenamide, and reduced secondary accelerator concentrations were necessary for adequate cure and safety. From that experience we explored further and found that, if the sulfenamide concentration is held constant at a higher level and the secondary accelerator concentration is increased as sulfur concentration is decreased, nearly equivalent hardness and modulus can be maintained throughout most cure conditions with no loss in safety and cure rate and much improvement in reversion resistance. Studies were made in a carbon black filled stock with N-cyclohexyl-2-benzothiazole sulfenamide (CBS), N-oxodiethylene-2-benzothiazole sulfenamide (DBS), and N-morpholinyl-2-benzothiazolyl disulfide (MBD) as primary accelerators and tetramethylthiuram monosulfide (TMTM) and tetramethylthiuram disulfide (TMTD) as secondary accelerators.

This publication has 0 references indexed in Scilit: