Oblique machining with a single cutting edge
- 30 June 1964
- journal article
- Published by Elsevier in International Journal of Machine Tool Design and Research
- Vol. 4 (1) , 9-25
- https://doi.org/10.1016/0020-7357(64)90006-x
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- New Development in the Theory of the Metal-Cutting Process: Part II—The Theory of Chip FormationJournal of Engineering for Industry, 1961
- ON THE SIZE EFFECT IN METAL CUTTINGInternational Journal of Production Research, 1961
- Fundamental Research on the Metal Cutting (2nd Report) : The Theoretical Equation of the Indentation-Force acting on a Cutting Edge and it's Experimental DiscussionTransactions of the Japan Society of Mechanical Engineers, 1956
- Deformation Work Absorbed by the Workpiece During Metal CuttingTransactions of the American Society of Mechanical Engineers, 1953
- Fundamental Researches on the Metal Cutting (1st Report) : A New Analysis of Cutting ForceTransactions of the Japan Society of Mechanical Engineers, 1953
- The Size Effect in Metal CuttingTransactions of the American Society of Mechanical Engineers, 1952
- The Theory of Plasticity Applied to a Problem of MachiningJournal of Applied Mechanics, 1951
- Mechanics of the Metal Cutting Process. II. Plasticity Conditions in Orthogonal CuttingJournal of Applied Physics, 1945
- Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 ChipJournal of Applied Physics, 1945
- Basic Mechanics of the Metal-Cutting ProcessJournal of Applied Mechanics, 1944