Modification of polyetherurethane for biomedical application by radiation induced grafting. II. Water sorption, surface properties, and protein adsorption of grafted films
- 1 July 1984
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 18 (6) , 655-669
- https://doi.org/10.1002/jbm.820180607
Abstract
A series of polyetherurethane films grafted by means of γ radiation with hydrophilic or reactive monomers (2-hydroxyethyl methacrylate, 2,3-epoxypropyl methacrylate, 2,3-dihydroxypropyl methacrylate, and acrylamide) and partially chemically modified were subjected to various physico—chemical investigation methods involving water sorption, contact angle, and protein adsorption measurements. From contact angle data the interfacial free energy γsw between grafted films and water was calculated. It was found that the water uptake of grafted films increases with grafting yield or, in the case of grafted and afterwards chemically modified films, with reaction yield; the diffusion coefficient of water in the modified films also increases with grafting yield. Contact angle studies revealed all grafted films to have surfaces more hydrophilic than the ungrafted trunk polymer. The degree of hydrophilicity—especially of HEMA-grafted films—strongly depends on grafting conditions. For some grafted samples with high surface hydrophilicity very low interfacial free energies approaching zero were measured. The study of the competitive adsorption of bovine serum albumin, γ-globulin, and fibrinogen from a synthetic protein solution onto modified films showed that the adsorption of albumin increases markedly with increasing grafting yields, whereas the fibrinogen and γ-globulin adsorption only slightly increases. A correlation between interfacial free energy and protein adsorption in the sense of the “minimum interfacial free energy hypothesis” was found only for samples with grafting yields below 5%. At higher grafting yields the increased surface area complicates the analysis.This publication has 18 references indexed in Scilit:
- Proteinadsorption an verschiedenen Kunststoffoberflächen in vitroBiomedizinische Technik/Biomedical Engineering, 1978
- Some Current Problems and new Dimensions of Polymeric Biomaterials for Blood-Contacting ApplicationsBiomaterials, Medical Devices, and Artificial Organs, 1978
- Measurement of the polar force contribution to adhesive bondingJournal of Colloid and Interface Science, 1974
- Aspects of three types of hydrogels for biomedical applicationsJournal of Biomedical Materials Research, 1973
- A technique for the characterization of hydrophilic solid surfacesJournal of Colloid and Interface Science, 1972
- Forces involved in the adhesive processJournal of Colloid and Interface Science, 1970
- Forces involved in the adhesive processJournal of Colloid and Interface Science, 1970
- Discussion of correlations of blood coagulation with surface properties of materialsJournal of Biomedical Materials Research, 1968
- Experimental analysis of interfacial forces at the plane surface of solidsThe Journal of Physical Chemistry, 1967
- THE EFFECT OF CHEMICAL STRUCTURE AND SURFACE PROPERTIES OF POLYMERS ON THE COAGULATION OF BLOOD. I. SURFACE FREE ENERGY EFFECTSAsaio Journal, 1965