Damping Measurements On An Offshore Platform

Publisher Website
Google Scholar
Abstract
Ambient and forced vibration tests were recently conducted on an offshore steel template platform in the Ekofisk complex of the North Sea. Valuable information about the dynamic characteristics of the structure was obtained. This paper focuses on the measurement and analysis of damping data for the platform. Modal damping values are very important in the dynamic analysis of offshore structures. Correct values of modal damping need to be utilized for the dynamic analysis to accurately predict the response of the structure. Little experimentally verified information of the modal damping characteristics of the fundamental and higher order modes of offshore structures is currently available. Damping values were calculated for the fundamental and higher order jacket modes which included natural frequencies up to approximately 5 Hz. Damping values are compared for forced and ambient vibration data, for bandwidth and response techniques, and for different excitation levels. The general results indicated that the fundamental modes important in fatigue had damping values of 1 to 3 percent of critical and the higher order modes had damping values of 2 to 3 percent of critical. Emphasis is placed on the apparent merits and limitations of the data presented. Response comparisons are also presented using an analytic model of the platform with various values of critical damping. INTRODUCTION: Accurately predicting the dynamic behavior of offshore oil and gas production platforms to withstand the effects of earthquakes and environmental fatigue due to wind and wave loading is an essential part of the design of such structures. Research and development work currently being undertaken to apply integrity monitoring techniques to these platforms also requires an accurate interpretation of the structural dynamic behavior. These applications of vibration technology translate directly into cost effective design and increased reliability and safety of offshore structures. The complexity of these structures requires a high level of theoretical analysis in developing models which duplicate the dynamic behavior under design loading conditions. Current state-of-the-art modeling methods usually apply finite element techniques which discretize the structure into an assemblage of mass and stiffness matrices which mathematically define the structure. The complexity of these structures also implies the need for confirmation and improvement of the structural models by experimental techniques. Using system identification methods, both analytic and experimental results can be used to accurately define the dynamic behavior of structures. Structural damping is one of the least understood yet most vital design characteristics of dynamically loaded structures. An analytical model of a structure in which low critical damping values are used will respond much differently to environmental loads than one in which higher damping values are used. This paper presents values of critical damping obtained experimentally on an offshore platform and comparisons are made to an analytic model of the structure. The vibration tests were conducted on an offshore steel template platform in the Ekofisk complex of the North Sea. Both ambient and forced vibration test procedures were utilized.

This publication has 0 references indexed in Scilit: