A 94-GHz Diode-Based Single Six-Port Reflectometer
- 1 August 1982
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 30 (8) , 1260-1264
- https://doi.org/10.1109/TMTT.1982.1131235
Abstract
This paper describes design considerations and gives measurement results for a single six-port reflectometer constructed from WR-10 waveguide with silicon Schottky diode detectors. Tradeoffs between various types of power detectors are discussed along with criteria for six-port junction design. The merits of two calibration procedures are compared. Measurements at 94 GHz indicate good agreement between expected and experimental values of q-points and of a sliding mismatch with nominal 0.1 reflection coefficient.Keywords
This publication has 5 references indexed in Scilit:
- A Dual Four-Port for Automatic Network AnalysisPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Analysis and calibration theory of the general 6-port reflectometor employing four amplitude detectorsProceedings of the Institution of Electrical Engineers, 1979
- Calibrating the Six-Port Reflectometer by Means of Sliding TerminationsIEEE Transactions on Microwave Theory and Techniques, 1978
- The Six-Port Reflectometer: An Alternative Network AnalyzerIEEE Transactions on Microwave Theory and Techniques, 1977
- A New Calibration Technique for Automated Broadband Microwave MeasurementsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1976