An explanation of the discrepancy in gapwise‐density variation of injection‐molded parts between Kamal's and Greener's data
- 1 November 1988
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 28 (22) , 1509-1512
- https://doi.org/10.1002/pen.760282212
Abstract
No abstract availableKeywords
This publication has 6 references indexed in Scilit:
- Effect of a pressure-dependent viscosity on the packing stage in injection moldingIndustrial & Engineering Chemistry Research, 1987
- General consequences of the packing phase in injection moldingPolymer Engineering & Science, 1986
- Pressure‐Induced densification in injection moldingPolymer Engineering & Science, 1986
- Pressure build‐up during the packing stage of injection moldingPolymer Engineering & Science, 1985
- Microstructural characterization of injection‐molded articlesJournal of Applied Polymer Science, 1983
- Distribution of some physical properties in injection‐molded thermoplastic partsPolymer Engineering & Science, 1977