Injection molding in disk‐shaped cavities
- 1 September 1977
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 17 (9) , 706-710
- https://doi.org/10.1002/pen.760170909
Abstract
No abstract availableKeywords
This publication has 5 references indexed in Scilit:
- On the Stability of Flow in Channels with a Moving Boundary: The Mold Filling ProblemTransactions of the Society of Rheology, 1977
- Mold‐filling studies for the injection molding of thermoplastic materials. Part II: The transient flow of plastic materials in the cavities of injection‐molding diesPolymer Engineering & Science, 1975
- Mold‐filling studies for the injection molding of thermoplastic materials. Part I: The flow of plastic materials in hot‐ and cold‐walled circular channelsPolymer Engineering & Science, 1975
- The injection molding of thermoplastics part II: Experimental test of the modelPolymer Engineering & Science, 1972
- The injection molding of thermoplastics part I: Theoretical modelPolymer Engineering & Science, 1972